The magnetic connector is mostly made up of a pogo pin, and a magnet is used in much electronic equipment so that the magnet and the pogo pin touch and attract each other.

Connector failure one: poor contact

In terms of structure, the metal conductor inside the connector is the core part of the overall device. It is used to connect the voltage or current of the externally connected wire or cable, and the data signal is equal to its mutual coordination and transmission to it. Therefore, the connector design must be well-structured, with reliable stability and good electrical conductivity. This happens often, and there are many reasons why. For example, it could be because the contact parts of the connector needed to be designed better, the wrong materials were used, or the processing size needed to meet the design requirements. If the roughness or installation method weren't the same, it would cause a bad connection between the connector and the device. If an electronic device stops working, the first problem to look at is the contact problem. Check all the connectors, and consider others when the connection is tight. If it's not a problem with the internal connection, a simple plug-and-play operation can fix it very well.

In addition, it is also very important to pay attention to the protection of the connector during use. Poor contact is sometimes caused by improper protection, which causes the connector to be partially damaged or corrupted. This situation causes poor contact. It is generally difficult to repair, and the connector needs to be replaced, which is not only troublesome but also a waste of resources and economic loss.

Connector failure two: poor insulation

This is mainly the impact of the external environment. Generally, in this case, the performance will be unstable, and the electricity leakage will be more terrible, which will cause unsafe factors in use. It can be observed intuitively, but when encountering such problems, it must be To stop working the connector and replace it with a new one.

There is also a problem involved here, which is the reason for the poor insulation. Due to the existence of excess substances on the surface or inside of the insulator equipment, such as common dust, burrs, and other adsorbents, will cause the insulation material to absorb moisture for a long time, aging. Occurs in the occurrence of short circuits, leakage, and failure. It is our choice if the insulation material needs to be revised. If there is a situation caused by environmental influence, it is caused by improper use and poor protection, especially moisture. The damage of the corrosive environment to the insulation layer of the connector makes us very entangled. This must be avoided as much as possible to avoid unnecessary losses, especially the protection of leakage, and may involve human safety issues. Therefore, when using it, special attention should be paid to the protection of the insulator to prevent faults caused by poor insulators.

Connector failure three: the connector is unstable

Due to poor fixation or slight shaking, the connector can be powered off, and more seriously, it will cause the connection to be interrupted and the product to disintegrate. This can generally be avoided by changing the installation method, especially by paying attention to the rationality of installation and the close combination of installation and use; this problem will not occur. Therefore, when choosing, it should be as close as possible to connect the devices and select products with a design that meets the requirements and relatively mature technology.